Thoughtful Thursdays: I Got Your Back!

Did you ever wish you could attach a cute little 3D embellishment to your project but were reluctant because it was hollow in the back with only a very thin edge? I know I've asked myself, "how can I do this and be sure it's going to stay put?" Well, I'm going to share with you my special method! So... here we go...

Step 1: Grab your embellishment and protect your work table with a non-stick surface. Here I'm using Ranger's Non-Stick Craft Sheet. 

Step 2: Tear up small pieces of paper towel. Paint one piece with a gel medium on both sides. Make sure it's nice and saturated, but not drippy. I'm using Claudine Hellmuth Studio Multi-Medium, also from Ranger.

Step 3: Next you're going to take your gel medium-soaked piece of paper towel and "stuff" it inside your embellishment. You can use a toothpick to make sure it's pushed into all the little nooks and crannies.

Continue painting your pieces of paper towel with gel medium and pushing them into the back of your embellishment until they are even with the back edge of the charm (you can even turn it over onto your non-stick surface for one final "push" to make sure the paper towels are nice and even). Let this dry overnight.

Step 4: So now your embellishment is ready to securely be added to whatever surface you like. Here is the necklace that's waiting for it's little brass kitty cat. Put a glob of gel medium onto the backside of your "stuffed" embellishment and put in place. Don't press it all the way onto your piece too hard. Place it so that there is just a wee bit of "breathing room" for the medium. You'll get a much better hold that way, as all your glue won't all squish out from underneath your charm.

Well, I hope you enjoyed this process as I know I did when I tried it. Opens up a whole new set of possibilities!